Configuration settings

Configuration settings example

Here is an example of a complete set of config settings for Archivematica 1.0-dev. This will run a transfer through from Approve transfer to uploadDIP and storeAIP.

<processingMCP>
    <preconfiguredChoices>
        <preconfiguredChoice>
            <appliesTo>Workflow decision - create transfer backup</appliesTo>
            <goToChain>Do not backup transfer</goToChain>
        </preconfiguredChoice>
        <preconfiguredChoice>
            <appliesTo>Workflow decision - send transfer to quarantine</appliesTo>
            <goToChain>Skip quarantine</goToChain>
        </preconfiguredChoice>
        <preconfiguredChoice>
            <appliesTo>Remove from quarantine</appliesTo>
            <goToChain>Unquarantine</goToChain>
            <delay unitCtime="yes">50</delay>
        </preconfiguredChoice>
        <preconfiguredChoice>
            <appliesTo>Create SIP(s)</appliesTo>
            <goToChain>Create single SIP and continue processing</goToChain>
        </preconfiguredChoice>
        <preconfiguredChoice>
            <appliesTo>Select normalization file identification tool</appliesTo>
            <goToChain>file extension</goToChain>
        </preconfiguredChoice>
        <preconfiguredChoice>
            <appliesTo>Normalize</appliesTo>
            <goToChain>Normalize for access</goToChain>
        </preconfiguredChoice>
        <preconfiguredChoice>
            <appliesTo>Approve normalization</appliesTo>
            <goToChain>Approve</goToChain>
        </preconfiguredChoice>
        <preconfiguredChoice>
            <appliesTo>Select compression algorithm</appliesTo>
            <goToChain>lzma</goToChain>
        </preconfiguredChoice>
        <preconfiguredChoice>
            <appliesTo>Select compression level</appliesTo>
            <goToChain>5 - normal compression mode</goToChain>
        </preconfiguredChoice>
    </preconfiguredChoices>
</processingMCP>